JELCON GEC SERIES instantly produces tough and elastic ink film with UV irradiation. This ink film is peelable from certain materials.

• GEC-6S : Glass, transfer paper
• GEC-10H : Stainless, glass. Non-silicone type.

• Tough ink film peels off easily and does not leave the trace of peeling.
• As the ink is 100% non-volatile, odor is low and the ink is suitable for thick coating.
• Peelability is not affected by humidity and heating.
• Reproducibility is good. Ink hardly leaks from screen, which makes the pattern be reproduced accurately.
• As the ink film is elastic, it is suitable for sand-blast process.

• Stir well before use.
• Screen : Stainless 120 meshes/inch(coating thickness : 30-40 microns)
• Use the ink at 15-30°C(59-86°F) of environmental temperature avoiding direct sunlight.
• Use VINYL CLEANING THINNER for washing up.

• One metal halide lamp : 120W/cm
• Distance from focus : 10cm
• Conveyor speed : 10m/min (Integral light : approx.250 mJ/cm²)
  Good reproducibility and levelling without after-tackiness can be obtained under these reproduced accurately.

1 kg plastic container

1. Although skin irritation(P.I.I.) is low, it is advised to avoid skin contact. In case of skin contact, please wash with soap and water immediately.
2. Store the ink in a cool and dark place. Stir occasionally to keep stability when the ink is stored for a long time. Use up the ink within 6 months.
3. Please refer to MSDS before use.

• Appearance : Uniform blue paste
• Sand-blast resistance : Resistant to 4 kg/cm² pressure
• Peelability : Peeled off by washing with hot water of 40-60°C(104-140°F) for 10 minutes
• Be sure to do trial print before commercial run to confirm that the product fits the purposes.

• GEC-6S
  UV power – 540mW/cm²
  Integral light – 380mJ/cm²
  Coating thickness – 50 microns
• The information herein is the data obtained form our lab test and does not imply any guarantee.