3100 SERIES FM INK is two-component type of ink that dries at low temperature. FM INK is suitable for plastics or films which cannot stand drying at high temperature. FM INK can be used for the applications that requires post-processability, heat-resistance or solvent resistance.

Treated PET film for insert-molding that requires heat resistance. Electric appliances and name plates of ABS, acryl, rigid vinyl and polycarbonate.

• FM INK adheres to wide range of substrates.
• FM INK dries at low temperature(70-80°C)(158-176°F).
• Excellent resistance to heat, chemicals and solvent.
• Long pot life. Good stability on the machine. Good printability.

Add FM HARDENER by 10-15% and thinner by 10-30% to the ink and stir well. Use PC THINNER(fast drying, standard drying, slow drying, retarder).

Standard drying conditions: 70°C(158°F) 30 minutes or 80°C(176°F) 20 minutes. Although FM INK dries at lower temperature, it takes longer to dry. Tack free condition can be obtained by drying at room temperature (approx.10-30 minutes). However, as it takes 4~6 days to dry at room temperature, above mentioned forced drying are recommended.

8 hours at room temperature. It is not advised to use the mixture after pot life as the properties of ink film degrade although the mixture is fluid enough to print even after30-40 hours.

Add accelerator, JA-E111 is added, pot life becomes shorter as below.

• Addition 2% : Approx. 6 hours
• Addition 4% : Approx. 4 hours

Use photo-stencil. VINYL CLEANING THINNER is recommended for washing up.

• Standard 18 colors, EXO(extra opaque) 5 colors, transparent 4 colors. 1kg can
• FM HARDENER : 0.1kg can, 0.4kg can
• JA-E111 : 0.05kg can

1. HARDENER reacts to humidity and gels. Do not leave the container with its lid open. Store the HARDENER in a cool and dark place with the lids tightly closed. HARDENER is effective for about 3-months after delivery if stored as instructed.
2. Please refer to (M)SDS before use.
3. Be sure to do trial print before commercial run to confirm that the product fits the purposes.

Substrate : Treated PET film of 125 microns(Higashiyama Film HK-31WF)
Fabric : 250 meshes/inch.
Ink :
3101 white, 3108 red, 3190 black(10% HARDENER, PC THINNER standard drying) 3 colors are printed in the order of red, black and white.
Drying :
80°C(176°F), 10 minutes in the working process, 80°C(176°F), 20 minutes at final stage.
Test was performed after leaving the work at room temperature for 1 day.

• Weathering resistance depends on the color. Please refer to lightfastness chart before use.
• Weathering resistance is remarkably degraded if the ink is diluted with white ink or clear ink.
   
• The figures in the physical properties table are test result, and are not guaranteed.
• The contents of this information are subject to change or revision without notice.